CUTMASTER 60i
3.03
Opening the Main Switch Cover
Systems are configured for and come with power cord connected for single phase or three phase configuration
depending on system purchased. The input power switch is located on the rear panel along the top. To access the
input locations, remove the screw at the top of the cover and flip down.
3.04
Primary Input Power Connections, SINGLE Phase
!
3-2
CAUTION
Disconnect power before removing the
cover.
Main Switch Cover
WARNING
Each CutMaster 60i system is a dedicated 1 Phase OR 3 Phase
system and cannot be reconfigured to the other. Personal injury
could occur if changing the phase is attempted..
CAUTION
The primary power source, fuse, and any extension cords used must
conform to local electrical code and the recommended circuit protec-
tion and wiring requirements as specified in Section 2.
Single-Phase (1ø)
Power Switch
Single Phase Input Power Wiring
INSTALLATION
Power Cord
GND
Manual 0-5475