Receipt Of Equipment; Power Supply Specifications - Thermal Dynamics CUTMASTER 60i Service Manual

CUTMASTER 60i
2.03

Receipt Of Equipment

When you receive the equipment, check it against the invoice to make sure it is complete and inspect the equipment
for possible damage due to shipping. If there is any damage, notify the carrier immediately to file a claim. Furnish
complete information concerning damage claims or shipping errors to the location in your area listed on the back
cover of this manual.
Include all equipment identification numbers as described above, along with a full description of the parts in error.
Art# A-13290
Move the equipment to the installation site before un-boxing the unit. Use care to avoid damaging the equipment when
opening the box.
2.04

Power Supply Specifications

1 Phase
Input Power
1 Phase Input Power Cable
Output Current
Power Supply Gas Filtering
Maximum Inlet Pressure
Ambient Air Temperature
* NOTE: The duty cycle will be reduced if the primary input power (AC) is low or the
2-2
60i 1 Phase Power Supply Specifications
208 - 480 VAC(187 - 528 VAC), Single Phase, 50/60 Hz
Power Supply includes 9' single phase 8AWG 3/C input
Ability
60i Power Supply Duty Cycle *
Duty Cycle
All Units
Current
DC Voltage
output voltage (DC) is higher than shown in this chart.
INTRODUCTION
Included items:
• 60i Power Supply
• SL60QD™ Torch and Leads
• Work Lead with Work Clamp
• Spare Parts Kit ( 2 Electrodes, 2 Tips, 6 O-rings)
• Operating Manual
• Filter Wrench
cable with NEMA 6-50P Plug..
10 - 60 Amps, Continuously Adjustable
Particulates to 5 Microns
125 PSI (8.6 bar)
Duty Cycle Ratings @ 40° C (104° F)
Operating Range 0° - 50° C
Rating
50% 60%
60 Amps 50 Amps
126 122
100%
40 Amps
119
Manual 0-5475