Thermal Dynamics CUTMASTER 60i Service Manual page 77

Control Panel
The cover does not have to be removed to replace the Control Panel. The following illustrations show the cover
removed.
1. Remove the two M5x0.8x12mm hex screws at the bottom corners of the Control Panel.
2. Carefully pull the bottom of the Control Panel outward and allow the panel to move down enough to release
the locking tabs along the top.
3. Move the Control Panel out from the power supply only enough to access the ribbon cable harness where
it attaches to the rear of the Control Panel.
4. Push the two locking tabs out from the ribbon cable connector to release and detach the cable from the
Control Panel.
Procedure is complete.
Manual 0-5475
WARNING
Disconnect primary power to the system
before disassembling the torch, leads, or
power supply.
Art # A-13316
Locking tabs
Art # A-13317
SERVICE
CUTMASTER 60i
5-43