Thermal Dynamics CUTMASTER 60i Service Manual page 3

WARNING
!
Read and understand this entire Manual and your employer's safety practices
before installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's
best judgement, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply
CutMaster™ 60i
SL60QD™ 1Torch™
Service Manual Number 0-5475
Published by:
ESAB Group Incorporated
2800 Airport Rd.
Denton, Texas 76207
www.esab.com
© Copyright 2017 by
Thermal Dynamics an ESAB brand.
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or
damage caused by any error or omission in this Manual, whether such error results from negli-
gence, accident, or any other cause.
Original Publication Date: April 3, 2017
Revision Date:
Record the following information for Warranty purposes:
Where Purchased:_______________________________ __________________
Purchase Date:__________________________________ __________________
Power Supply Serial #:___________________________ ___________________
Torch Serial #:___________________________________ _________________
i