Switch Shut-Down Procedure; Figure 74: Spine Side Panel Display Status Indications; Figure 75: Management Module Status Indications For Normal Operation (Master); Figure 76: Management Module Status Indications For Normal Operation (Slave) - Mellanox Technologies Switch-IB User Manual

Check the Management Module LEDs and make sure they coincide with
Step 5.

Figure 75: Management Module Status Indications for Normal Operation (Master)

Figure 76: Management Module Status Indications for Normal Operation (Slave)

Connect the system to the power main.
Step 6.
Make sure all that PSUs get powered on.
Step 7.
4.2

Switch Shut-Down Procedure

The chassis cannot be shut down using remotely. To shut it down, the power plugs need to be
physically pulled from the power grid.
To reboot any of the modules accessible through CLI, the command "reload" must be run on
them in configuration mode "Config" as shown in the following:
switch (config)# reload
Mellanox Technologies

Figure 74: Spine Side Panel Display Status Indications

Chassis Power Up
Figure 75.
89