Figure 52: Intact Spine Signal Connectors; Figure 53: Intact Spine Power Pin Holders - Mellanox Technologies Switch-IB User Manual

Check power connector's integrity. Look for any damage on the power connector casing or
Step 3.
blades damage, or any deviations from the pass criterion shown in
Start with the ejector handles fully open; that is, at 45 degrees to the front panel of the spine.
Step 4.
Holding the spine by its sides, carefully set the spine module halfway into the chassis.
Step 5.
Using only the ejector handles, slowly slide the module into the chassis until the hooks
Step 6.
reach the vertical bar.
Catch the ejector handle hooks onto the vertical bar of the chassis and push the ejector han-
Step 7.
dles shut
Mellanox Technologies

Figure 52: Intact Spine Signal Connectors

Figure 53: Intact Spine Power Pin Holders

Do not use the fan FRU handle to insert the spine module.
Do not apply excessive force to slide in the spine module. If you feel resistance,
remove the spine and double check both the chassis and spine for any damage.
(Figure 54).
Installation
Figure 53.
67