How To Reset Odometer And Trip Meter - Furuno FMD-3200 Operator's Manual

Check position sensors (POSN page)
Open the menu and click the [POSN] tab in the [System Sensor Settings] page or [Lo-
cal System Settings] page. The [Prim] and [Second] labels indicate the type of the po-
sition sensor. (In the figure below the [Prim] label shows FILT). [Prim] and [Second]
indicate sensor status and priority.
Only one sensor can be Primary1 while the others are Primary2 or off position. After
a sensor is turned off, its status is changed to Primary2 state. When a position sensor
state is changed to Primary1 and another sensor was Primary1, the sensor formerly
primary1 becomes Primary2.
Select the Primary1 navigation sensor as the sensor that is considered to be most ac-
curate and reliable. Set all other navigation sensors as Primary2.
2.11.5

How to reset odometer and trip meter

To reset the odometer and/or trip meter do as follows:
1. Open the menu and select the [Voyage] menu from the [NAVI Log] menu.
2. Click one of the following buttons as appropriate.
Reset Trip: Reset the trip distance (ground and water).
Reset All: Reset both the odometer and the trip meter (ground and water).
3. Click the [Close] button to finish.
Second shows Integrity as "Not available" when
only one position-fixing equipment is connected.
2. OPERATIONAL OVERVIEW
FILT
LAT: 35°15.743'N
LON: 139°50.064'E
Integrity: Passed
LAT:
LON:
Integrity: Not Available
2-29