System Configuration - Furuno FMD-3200 Operator's Manual

SYSTEM CONFIGURATION

Single workstation
HD26T21-MMD-MA4-FAGA
Category of units
All units protected
from the weather.
Dashed lines indicate
optional or local supply
equipment.
IF Signal:
- Serial Interface x2 (IEC 61162-1/2)
- Serial Interface x6 (IEC 61162-1)
- Digital Out x6
(power fail/system fail/ NO x2, NC x2)
- Digital In (ack in)
Note: The following monitors are
available with the FMD-3200-BB:
Model Maker
MU-190 FURUNO JH23T12FUD
MU-231 FURUNO JH23T14FUD
MU-201CE FURUNO HD24T21MMD Hatteland
MU-231CE FURUNO JH26T11MMD Hatteland
JH19T14FUD Hatteland HD26T21MMD Hatteland
JH20T17FUD Hatteland
For information about a Hatteland monitor, see its
Operator's Manual.
xiv
Main Monitor Sub Monitor
Monitor Unit
Monitor Unit
MU-190
MU-190
MU-231
MU-231
ECDIS
Control Unit
RCU-024
or
Trackball
Control Unit
RCU-026
ECDIS
Control Unit
RCU-024
or
EC-3000
Trackball
PROCESSOR
Control Unit
UNIT
RCU-026
(Max. 2)
Model Maker
Hatteland
Hatteland
Conning
Monitor
Monitor Unit
MU-190
MU-231
Switching
Sensor Adapter
Hub
MC-3000S
HUB-100
Sensor Adapter
MC-3010A
Sensor Adapter
MC-3020D
Sensor Adapter
MC-3030D
Intelligent
Hub
Gateway network equipment
HUB-3000
(radar, ECDIS, etc.)
100-115/
220-230 VAC,
1ø, 50/60 Hz
Monitor viewing distance (m):
Model Viewing Dist.
MU-190 1.0138 JH23T12FUD
MU-231 1.0138 JH23T14FUD
MU-201CE 1.0759 HD24T21MMD 0.9517
MU-231CE 1.0138 JH26T11MMD 0.9879
JH19T14FUD 1.0138 HD26T21MMD 0.9879
JH20T17FUD 0.8793
Serial interface
Analog interface
Digital IN interface
Digital OUT interface
Model Viewing Dist.
1.0138
1.0138