Furuno FMD-3200 Operator's Manual page 336

26. AUTOPILOT OPERATIONS
FU Override NFU Controller
Starting steering override:
1) Confirm that the Ready lamp in
the NFU controller is ON.
2) Pull out the pin stopper insert-
ed in the override NFU control-
ler and turn the lever to the
desired direction. Beeps
sounds then the selected
steering mode flashes. The ON
lamp in the Override reset unit
is lit.
3) The rudder is taken when the
lever is turned, and the rudder
stops when the lever is re-
turned to the neutral position.
Stopping steering override:
1) Push the Override steering re-
set switch on the override reset
unit in the steering stand to re-
turn to the previous steering
mode.
2) If the steering mode was AU-
TO, the heading at the time the
override steering became ac-
tive is set as heading. Auto re-
sume is disabled if the steering
mode was RC/NAV. To restore
the RC mode, turn the mode
selection switch to another
steering mode then select the
RC mode again.
26-8
Ready lamp
Override steering
lever
Pin stopper
Override indicator
Override steering
reset switch
Dimmer knob