How To Mark Mob Position - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
5. For automatic input follow the procedure below. For manual input go to step 6.
1) Check [Sensors].
2) For local system settings, set the priority for each sensor connected, referring to
section 1.10.
3) Go to step 7.
Note: For the local sensor, an offset can be applied to the gyro reading if it is
wrong. Check [Gyro Correction], then spin the scrollwheel to set the offset.
6. For manual input, check [Manual]. Enter heading by spinning the scrollwheel or
entering numeric data with the keyboard on the Control Unit.
7. Click the [Save] button to save settings then click the [Close] button to close the
menu.
1.12

How to Mark MOB Position

Use the MOB (man overboard) feature to mark the position of man overboard on the
display screen. Access the [MOB] button (in any mode) on the InstantAccess bar.
[MOB]
button
The MOB mark (orange) instantly appears at the system position when the button is
operated.
Up to 100 MOB marks can be saved. When the capacity for MOB marks is reached,
the oldest mark is automatically erased to make room for the latest.
To hide an MOB mark, get into the Navigation voyage mode (NAVI) or Voyage plan-
ning mode (PLAN), right-click the mark to show the context-sensitive menu then select
[Hide MOB].
Exercise caution when using this feature in strong tide or current. The person will not
be at the MOB position for a very long time.
1-12