Trip Alarm; How To Set The Trip Alarm; How To Reset The Trip Log - Furuno FI-70 Operator's Manual

3. ALARMS
3.4

Trip Alarm

The trip alarm is activated when the total distance traveled reaches the set threshold.
The total distance traveled is calculated from the moment the FI-70 is powered for the
first time. This distance is stored in the trip log.
3.4.1

How to set the trip alarm

1. Access the [Alarms] menu, using the procedure outlined on page 3-1.
2. Press the software keys to select [Trip Alarm], then press the function key.
3. [Alarm] is highlighted, press the function key.
4. Select [OFF] or [ON] as appropriate, then press the function key.
• [OFF]: Disable the alarm. Proceed to step 7.
• [ON]: Enable the alarm.
5. Press the software keys to select the threshold, then press the function key.
6. Press the software keys to set the threshold as appropriate, then press the func-
tion key to apply the changes.
7. Press the Menu/Back key twice to close the menu.
3.4.2

How to reset the trip log

1. With a data box showing [Trip] displayed, press the Menu/Back key.
2. Press the software keys to select [Trip], then press the function key.
3. Press the software keys to select [Clear], then press the function key. The FI-70
displays the following confirmation message.
4. To reset the trip log, press the left software key. To abandon the log reset, press
the right software key.
5. Press the Menu/Back key to close the menu.
3-4
Clear trip log.
Are you sure?