How To Stop Monitoring A Route (Manual, Automatic); How To Select What Parts Of A Route To Display - Furuno FMD-3200 Operator's Manual

About monitoring routes
 When you choose a route for monitoring, the messages shown below appear, on the
[Select Route] dialog box or in a message window, when a route cannot be opened
for monitoring.
• "Impossible turn at waypoint XX" (XX=waypoint no.). Geometry of the route makes
it impossible for the ship to accomplish a turn. Modify the route to make the turn
possible.
• "Unchecked / Check condition differs". The route has not been checked. Check
the route, on the [Alert Parameters] page.
• "Monitored in the NAVI mode". The route is currently being monitored.
• "More than one WPT needed". The route has only one waypoint. Add more way-
points to the route.
• "Route monitoring cannot be started. Please check ship's position and conditions."
Click the [OK] button to close the message. Check ship's position and conditions
of the route.
 The route check which occurs after selecting a route can take longer with C-Map or
CM-ENC charts. Wait until the completion of the check.
 If you have small-scale chart(s) on display that have the whole eastern/western (0-
180°E/0-180°W) hemisphere and a part of the other hemisphere on display, there is
a limitation to display a route. To avoid this, set chart center so that the whole east-
ern/western hemisphere is not on the screen.
 Route monitoring is temporarily stopped (route is greyed out) and an alert appears
when position, speed or heading is lost. To restore route monitoring, change the sen-
sor system from System to Local (from the Sensor Information box), manually enter
the lost data, check [Set Drift], then switch to the DR mode.
 Route data is sent to the radar (ex. FAR-2xx7 series) at the start of route monitoring
or when the ship transits a waypoint. If a route is not displayed on the radar, stop then
restart monitoring at the ECDIS. A route is erased from the radar when route moni-
toring is stopped or the ECDIS is restarted. To redisplay the route, stop then restart
monitoring at the ECDIS.
11.2 How to Stop Monitoring a Route (Manual, Auto-
matic)
In the Voyage navigation mode, route monitoring can be stopped by clicking the
[Route] and [Unselect] buttons. When alert 691, 692 or 693 occurs, route monitoring
is automatically stopped. See " route monitoring is stopped" in the Troubleshooting table
in section 24.5 for details.
11.3

How to Select What Parts of a Route to Display

You can specify what parts
of the monitored route to
display. Click the [DISP],
[SET] and [Symbol DISP]
buttons on the InstantAc-
cess bar. Click the [Route]
tab.
11. HOW TO MONITOR ROUTES
11-3