How To Select Sensor Settings - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
Manual adjustment with the trackball module
1. Click the [BRILL] button on the InstantAccess bar to show the brilliance adjust-
ment window.
2. For coarse adjustment, put the cursor on a location within the slider bar area
then push the left button. For fine adjustment, put the cursor on the end of the
slider bar and roll the trackball while holding down the left button.
3. Release the left button to confirm setting. The calibration state indication changes
to "UNCALIB".
4. Click the [CALIB] button to calibrate the brilliance. The calibration state indication
changes to "CALIB".
1.9

How to Select Sensor Settings

This ECDIS system accepts navigation data input two ways: System or Local. System
shares sensor data among multiple ECDIS in network. Sensor priority is also com-
monly shared among the ECDIS. Local selects a sensor outside the network.
1. Right-click anywhere in the [Sensor infor-
mation] box to show the context-sensitive
menu.
2. Click [Local] or [System] as applicable.
Note: Sensor system can also be selected
from the menu. Open the menu and click
[System/Local Select] on the [Sensor]
menu. Click the circle next to [System Sen-
sor] or [Local Sensor] as appropriate then
click the [Save] button.
1-8
Open MENU