How To Select The Operating Mode - Furuno FMD-3200 Operator's Manual

2. To switch between the alphabet keyboard and symbols keyboard, click the [!$&]
key.
3. Click the input box.
4. Click appropriate keys and finally click the [Enter] key.
To erase the software keyboard, click the X button at the top right corner of the key-
board.
Alphanumeric data entry with the trackball module
The trackball module can also be used to enter alphanumeric data.
1. Put the cursor in the input box. Up and down arrows
appear at the right side of the box.
2. Enter data by one of the methods shown below.
• Spin the scrollwheel to set data. Upward to decrease the value; downward to
increase the value.
Note: The incrementing direction can be changed with [Wheel rotation] in the
[Customize] menu of the [Settings] menu.
• Click  to increase the value;  to decrease the value.
How to enter latitude and longitude data with the trackball module
The trackball module can also be used to enter latitude and longitude data.
1. Put the cursor in the input box. A selection cursor (light-
blue) appears.
2. Enter data by spinning the scrollwheel.
3. To switch coordinate between N and S and vice versa,
put the cursor at the right edge of the input box. Dual ar-
rows appear
4. Click to switch the coordinates. The method to switch E to W and vice versa is the
same.
2.2

How to Select the Operating Mode

Click the [Display Mode] button at the far left side of the Status
bar to select the operating mode, [ECDIS], [CONNING] or
AMS (option). [ECDIS] displays electronic charts. [CONNING]
display provides comprehensive navigation displays such as
wind direction and rudder angle, in analog and digital formats.
(Note that this button is inoperative if the conning display is fed
to another monitor.) See section 22.1. [AMS] opens the Alert
Management System. See Chapter 25.
Alphabet keyboard
2. OPERATIONAL OVERVIEW
Symbols keyboard
Selection cursor
[Display Mode] button
2-15