How To Select Time Format, Set Local Time; How To Take A Screenshot Of The Display - Furuno FMD-3200 Operator's Manual

1.13

How to Select Time Format, Set Local Time

A GPS navigator feeds time and date data (ZDA sentence) to the ECDIS and they ap-
pear on the Status bar. Neither the time nor the date can be adjusted, however you
can select between UTC time (default) and local time. You can switch between the lo-
cal time and the UTC time by left-clicking the Current time format indication.
Note: The date and time are yellow when the ZDA sentence is lost.
Current time format
Left click: Switch between
local and UTC times
Right click: Adjust local time
To set the local time, enter the time difference between the local time and the UTC
time as shown below.
1. Right-click the Current time format indication to show the context-sensitive menu
then click [Adjust Local Time] to display the [Local Time Adjust] dialog box.
2. Enter the time difference between the local time and the UTC time, in hours and
minutes. Use the button on the left to select the time offset direction. Select "+" if
the local time is ahead of the UTC time, or "-" if it is behind the UTC time.
1.14

How to Take a Screenshot of the Display

Click the [Capture] button on the InstantAccess bar to take a screenshot and save it
to the SSD (Solid State Drive). You can save a maximum of 100 screenshots. When
the memory for screenshots becomes full, you cannot take any more screenshots. In
this case, delete unnecessary screenshots. You cannot take a screenshot when a
menu or a dialog box is open. Screenshots can be copied to a USB flash memory. For
how to process screenshots, see section 23.10.
[Capture]
button
Time
1. INTRODUCTION
1-13