How To Turn The Power On/Off; The Standby Mode - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
1.3

How to Turn the Power On/Off

Normally, leave the power switches at the front of the Processor Unit on and control
the power with the power key on a Control Unit (RCU-024, RCU-026). The Monitor
Unit is powered independently.
How to power the system
Push the Mains switch on the Processor Unit for the "I" position. Turn on the power
switch on the Processor Unit or the power key on the Control Unit. The start-up display
appears on the monitor.
Note: If the ambient temperature is less than 0°C (32°F) when the power is applied,
nothing appears on the display. This is because the heater is warming the Processor
Unit. The display appears after the Processor Unit becomes warm, in approx. two min-
utes.
How to power off the system
Press the power switch on the Processor Unit or the power key on the Control Unit.
Then, push the Mains switch for the "O" position.
1.4

The Standby Mode

The standby mode, which requires a password to activate, deactivates the audio
alarms from the ECDIS. Use this mode when the ECDIS is not required, like in a har-
bor.
To go to the standby mode, first click the [OTHERS] button on the Status bar then click
[STANDBY]. Have the holder of the password enter the password then click the [OK]
button.
Click to return to normal operation.
To return to normal operation, click [Back to Normal Mode].
1-2
Click OTHERS,
STANDBY.
Playback
Enter password;
click OK button.