Installing options/accessories
7.3.3 Abductor with abductor extension
This option makes it possible to mount the abductor somewhat further to the front of the seat on the size 1 seating
unit.
1) Screw the abductor wedge loosely onto the abductor (see fig. 41, item 1).
2) Position the abductor extension on the seat plate and fasten it with screws from below (see fig. 42, item 1).
INFORMATION: When using a slip sack, make a cut in it in the specified spot (see Page 29), insert the
slip sack and fasten the abductor with screws.
3) Adjust the depth of the abductor in the slotted hole if necessary (see fig. 41, arrow).
4) Now fasten the abductor with screws.
41
7.3.4 Pelvic band
For installation information, consult the instructions that come with the product.
7.3.5 Chest and shoulder support
WARNING
Incorrect application
Throttling, suffocation or strangulation due to sliding forward/down in the product
► Always use the positioning system in combination with a correctly applied and adapted positioning pelvic har
ness to stabilise the pelvis.
► The positioning system has to fit closely but not too tightly so the user is not injured. It should be possible to
slide two fingers comfortably between the positioning system and upper body.
► The positioning system is intended to support the area of the upper body from the front. It has to be
applied/positioned so that the neck and area of the throat remain free at all times. Follow the positioning
instructions.
► Observe the information for proper application and adjustment of the product in these instructions for use so
that the user cannot slide into a hazardous position.
INFORMATION
Note the instructions for use and possible application errors (see Page 17, four-point belts), which apply here too.
22
42
Kimba Neo