Positioning Aids; Adjusting The Thoracic Supports; Adjusting The Abductor; Adjusting The Chest And Shoulder Support - Otto Bock Kimba Neo Instructions For Use Manual

1) Adapt the head support position according to the needs of the user. Various adjustment options are provided
for this purpose (see fig. 83; see fig. 84).
2) Retighten the screws after completing the adaptation.
83

8.4 Positioning aids

CAUTION
Improper adjustment
Crushing or pinching due to adjustments which are too tight
► Do not pinch the user when sliding in the product.

8.4.1 Adjusting the thoracic supports

1) Loosen the knurled nuts on the back of the back insert.
2) Adjust the width/height by moving the supports in the slotted holes (see fig. 85).
INFORMATION: If necessary, you can adjust the height of the supports by shifting the mounting
screws in the slotted hole of the back plate.
3) Hand-tighten the knurled nuts.
85

8.4.2 Adjusting the abductor

The abductor can be adjusted as follows:
• Shifting of the mounting screw to other holes/slotted holes of the seat plate (see fig. 39).
• Moving the abductor in the slotted hole (see fig. 40)

8.4.3 Adjusting the chest and shoulder support

INFORMATION
The application of the product is described in the Instructions for Use (User).
The chest and shoulder support can be adjusted as follows:
• Moving the belts in the 2 pairs of clips on the back plate (see fig. 45, item 2/3)
• Moving the belts in the sewn-on clips of the chest and shoulder support (see fig. 43, item 5).
Kimba Neo
84
Settings
35