Adjusting The Seat Width; Adjusting The Back Height - Otto Bock Kimba Neo Instructions For Use Manual

74

8.2.2 Adjusting the seat width

1) Loosen the 4 wing nuts on the underside of the seat (see fig. 76, item 1).
2) Adjust the seat width by moving the hip pads (see fig. 77). This also allows for abducted settings.
3) Hand-tighten the wing nuts.
4) If necessary: Adjust the depth of the hip pads. Do so by removing the cover on the pad, loosening the screws
in the lateral slots, adjusting the depth and retightening the screws (see fig. 78).
76
78

8.2.3 Adjusting the Back Height

1) Loosen the 2 set screws at the backrest tubes (see fig. 79, item 1).
2) Adjust the back insert to the desired height.
3) Tighten the set screws again.
INFORMATION: You can achieve a greater back height by additionally shifting the top back plate at
the back insert. To do so, loosen/remove the knurled nuts, shift the back plate and hand-tighten the
knurled nuts again.
Kimba Neo
75
77
Settings
33