Installing Options/Accessories; Headrests; Headrest Supports; Integrated Headrests - Otto Bock Kimba Neo Instructions For Use Manual

7 Installing options/accessories

INFORMATION
Please also observe the adjustment instructions in the section "Settings" (see Page 32 ff.).

7.1 Headrests

7.1.1 Headrest supports

1) Pull the proper sides of the headrest supports through the padding (see fig. 7).
2) Open the zipper of the padding cap (see fig. 5) and push the padding behind the seat to the side.
3) Put the mounting screws through the slotted hole in the headrest support and through the hole in the back
plate (see fig. 8).
INFORMATION: If the headrest supports are to be mounted to the top holes (= mounting points of the
back plate), the longer mounting screws, which come with the device, will have to be used instead of
the regular mounting screws.
4) Fasten the headrest supports on the back of the back plate using the knurled nuts.
5) If necessary, adjust the width. Hand-tighten the knurled nuts.
6) Close the padding again.
7

7.1.2 Integrated headrests

Assembly is done at the factory following receipt of an order.
To change the distance of the headrests: (adaptation of the integrated headrests).

7.1.3 Individually adjustable head supports (with "shortened back insert" option)

INFORMATION
To adjust the head support: see Page 34.
1) Insert the 2 mounting screws for the head support through the holes in the back plate and the head support
holder.
2) Install the cap nuts on the reverse side.
3) Tighten the screw connections (see fig. 9).
Mounting a second gooseneck in addition
A second gooseneck can be mounted on the head support if required:
1) Remove the head support from the gooseneck (not illustrated).
2) Install a receiver bushing (see fig. 10).
3) Assemble and screw together the 2 gooseneck components (see fig. 11).
4) Mount the head support on the upper end of the two-part gooseneck (see fig. 12, arrow).
5) Mount the assembly on the back plate (see above).
Kimba Neo
8
Installing options/accessories
11