Positioning Aids; Thoracic Supports; Abductor - Otto Bock Kimba neo Instructions For Use Manual

Preparation for Use
Completing the installation
► If necessary, cut off protruding belt ends of the shoulder belts and melt the free ends by applying heat (such as
from a lighter).
→ The five-point belt is installed properly if the latches can be clipped into the buckle (9).

5.2.3 Positioning aids

5.2.3.1 Thoracic supports

1) Run the proper sides of the thoracic supports through the padding.
2) Put the mounting screws through the slotted hole in the thoracic support and the back insert (see Fig. 24, Pos.
1).
3) Fasten the thoracic supports on the back of the back insert using knurled nuts.
4) If necessary, adjust the width/height. Hand-tighten the knurled nuts.

5.2.3.2 Abductor

1) Place the abductor in the desired position on the seat plate (see Fig. 25, Pos. 1) and fasten it with screws from
below loosely (see Fig. 26, Pos. 1).
INFORMATION: When using a slip sack, make a cut in it in the specified spot, insert the slip sack and
fasten the abductor with screws loosely.
2) Adjust the depth of the abductor in the slotted hole if necessary.
3) Now fasten the abductor with screws tightly.
16 | Ottobock
24
25 26
Kimba neo