Table of Contents
Advertisement
S A F E T Y R E G U L A T I O N S & I N T R O D U C T I O N
1.2.4
Hazards associated with the equipment.
The equipment is built with state-of-the-art technology and recognized safety regulations. Nevertheless, use of the
equipment can result in dangers to life and limb for the installer, user or a third party and in impairments to the
equipment or to other material property. The equipment must only be used
• For its intended purpose.
• In perfect condition in terms of safety requirements.
Operate the equipment in technically perfect condition and for its intended use only while bearing in mind all
safety and hazard considerations and following the operating instructions. In particular, faults which restrict safety
must be rectified immediately after they have been identified and at the latest before the equipment is started up.
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
This device complies with part 15 of the FCC rules. Operation is subject to the
2. This device must accept any interference received, including interference that
1.2.5
Warranty and liability.
Our "Sales terms and conditions" apply. These terms and conditions will have been available to the purchaser at
time of sale. Warranty and liability shall be limited to repairs and replacement to the equipment purchased from
us. Warranty and liability claims shall not be entertained if they can be traced back to one or more of the following
causes.
• Equipment not used for its intended purpose.
• Improper installation, startup, operation and maintenance of the equipment.
• Operation of the equipment with faulty safety devices or improperly installed or non-operational safety
and protective equipment.
• Failure to observe the information, instructions and notices contained in the operating instructions
relating to transportation, storage, installation, startup, operation, maintenance and setting up of the
equipment.
• Inadequate monitoring of the equipment parts which are subject to wear.
• Improperly conducted repairs.
• Catastrophes caused by the influence of foreign bodies and force majeure.
1.2.6 Organizational measures.
• The installer and or maintainer shall provide the necessary protective equipment for the personnel
• All existing safety equipment must be checked at regular intervals.
Compliance Testing for AS/NZS CISPR 22:2002 Class A
WARNING !
Compliance Testing for FCC Title 47 Part 15, Subpart B Class A
FCC PART 15
following two conditions:
1. This device may not cause harmful interference, and
may cause undesired operation.
Advertisement
Table of Contents
