Table of Contents
Advertisement
E E P R O M S E T T I N G S
Section 2: EEProm Settings
EEProm How to read and modify settings
This EEProm holds settings for the particular contract data including number of
floors, door type and drive types.
The EEPRom holds values for various contract settings which may be altered on site. Each setting has a definition
followed by its value in hex followed by its value in bit format.
To inspect the settings from the power up state,
press the forward ">" button located to the left
below the LCD until the EEPROM setting appears.
To inspect the settings from the power up state,
press the forward ">" button located to the left
below the LCD until the EEPROM setting appears.
Now you can use the up "∧" and down "∨"buttons
to scroll through the settings. If you want to change
a setting press the enter "ENT" button and a * shall
appear on the screen to indicate you are in edit mode.
Now use the up "∧" and down "∨" buttons to
change the setting. When you are at the required
value press the enter "ENT" button again and the *
shall disappear.
EEProm Security
A special write sequence has been added to ensure unauthorized writes to the EEProm are not made. Only
operates with EEProms with this capability. These EEproms are recommended and identified by a "contract data
secure" label.
01-
NOR IDL
][
ECD Aust. V-4.02
01-
NOR IDL
][
TOP: 08:00001000
01-
NOR IDL
][
TOP:*08:00000010
01-
NOR IDL
][
TOP: 06:00000010
Section
2
Advertisement
Table of Contents
