ECD 100-181 Manual page 51

M O T I O N
"SDX"
"ST2"
time
time
GMV 3010/S, Blain EV100, Maxton, Bucher LRV,
EECO. Setting "05"
1. On inspection SP3 turns on for inspection speed
VF Drive Type 2
C.T. Setting "06"
Note:
1. To initiate a run,
"PRV" must be active
prior to run.
"PRV" is not required on
inspection.
The end of the run is
initiated by loss of leveling.
BRK then holds up for SDX
time and then UD,U/D is
held up for ST2 time in 10ms
increments.
SDX time must be less than ST2 time
2. On inspection SP3 turns on for insp speed.
On inspection UF and DF turn off.
Note:
400ms
100 ms
"ST2"
"SDX"
time
time