ECD 100-181 Manual page 55

M O T I O N
VF Drive Type 6
Setting "0A" Gefran with DB
Similar to "03" with UD delay off for
Synch gearless AC. (drop DB contactor)
1 sec
Note:
1. To initiate a run, "PRV"
must be active prior to run.
"PRV" turns off during entire run and
becomes active to complete the run.
"PRV" is not required on inspection.
2. On inspection SP3 turns on for insp speed.
On inspection UF and DF turn off.
3. SP2 turns on for intermiediate speed (MSL=01 only)
4. UD relay has 1.0 sec delay off after completion of run
5. US/ DS used for terminal speed check on lifts above 1m/s
6. SO4/IRO turns on when performing a correction run. NOT used for INSP output
7. CFS and IND do not turn on OS output
1 sec