Table of Contents
Advertisement
E E P R O M S E T T I N G S
This signal can be used when a lift in the group doesn't go all the way to the bottom.
01: 00000001 (Level 1)
02: 00000010 (Level 2)
03: 00000011 (Level 3)
04: 00000100 (Level 4)
05: 00000101 (Level 5)
BST – Brake Switch Time
For brake switch monitoring.
BST sets the time that the BKSW input must be turned on (to prove the brake has lifted) once the brake lift
command (BRK relay pulled in) has been initiated.
Setting example:
01: 00000001 = 1s
02: 00000010 = 2s
03: 00000011 = 3s
04: 00000100 = 4s
05: 00000101 = 5s
FF: 11111111 = OFF. BKSW not monitored.
Any other setting than 01-05 will turn the brake switch monitoring OFF.
BST is a fatal error. Reset is only via a processor POR.
See also Input - Output, Sin1- BKSW.
CCMF - Car Call Mask (Front doors) setup
CCMF EEPROM
Car call mask. Front doors floors allowed. (MASK). For this lift only.
This setting lets you define the floors which the lift serves via the front doors.
Set bits to a "1" car call allowed or a "0" for not allowed.
C0: 11000000 (1c,2c)
E0: 11100000 (1c,2c,3c)
F0: 11110000 (1c,2c,3c,4c)
F8: 11111000 (1c,2c,3c,4c,5c)
FC: 11111100 (1c,2c,3c,4c,5c,6c)
Note: This masking feature shall not to be used as a means providing of floor security, as it shall disable the car
calls in Fire Service and other modes of operation.
CCMR - Car Call Mask (Rear doors) setup
CCMR EEPROM
Car call mask. Rear doors floors allowed. (MASK). For this lift only.
This setting lets you define the floors which the lift serves via the rear doors.
Set bits to a "1" car call allowed or a "0" for not allowed.
C0: 11000000 (1c,2c)
E0: 11100000 (1c,2c,3c)
F0: 11110000 (1c,2c,3c,4c)
F8: 11111000 (1c,2c,3c,4c,5c)
FC: 11111100 (1c,2c,3c,4c,5c,6c)
Note: This masking feature shall not to be used as a means providing of floor security, as it shall disable the car
calls in Fire Service and other modes of operation.
CNT - CNT Input setup
Enables the following CNT inputs to be inverted; DCBF, DOBF, EDPF, DCBR, DOBR, EDPR.
CNT EEPROM (MASK)
00: 00000000 No inputs inverted.
01: 00000001 DCBF. Door close front input inverted
02: 00000010 DOBF. Door open front input inverted
04: 00000100 EDPF. Light ray front input inverted
Advertisement
Table of Contents
