System Customizations; Headset Use; Headset Prior - Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone

System Customizations

Headset Use

If you want to use a wired headset, physically connect your headset to the phone and activate
the headset mode for use. For more information on physically connecting a headset, refer to
Phone Installation
If you want to use a wireless headset, insert the Bluetooth USB dongle BT40 into the USB port at
the back of the IP phone. For more information on using a Bluetooth headset, refer to
on page 100.
This section provides an introduction to wired headset use.
Note
If both a Bluetooth headset and a wired headset are connected, only the Bluetooth headset can
be used.
To use headset, make sure the headset mode is enabled. Contact your system administrator for
more information.
Headset Mode Activation/Deactivation
To activate the headset mode:
Press
1.
The HEADSET key LED illuminates solid green, and the icon
of the touch screen.
When you tap the line key or the Answer soft key to answer an incoming call, the call is
connected to your headset automatically. For more information on using the headset to
answer a call, refer to
With the handset on-hook, enter the desired number and tap Send, the phone will then
place a call using the headset automatically. For more information on using the headset to
place a call, refer to
To deactivate the headset mode:
Press
1.
The HEADSET key LED goes out, and the icon

Headset Prior

You can use headset in priority when headset prior feature is enabled. This feature is especially
useful for permanent or full-time headset users.
98
on page 18.
on the phone.
Answering Calls
Placing Calls on page 134.
again on the phone.
on page 136.
disappears from the touch screen.
Bluetooth
appears on the status bar