Semi-Attended Transfer - Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone
To perform a blind transfer to exist call:
Press
1.
Tap the desired hold call you want to transfer the call to on the left side.
2.
The call is then connected to the call to which you are transferring.

Semi-attended Transfer

Before performing a semi-attended transfer (except you use dial number method), make sure
that the transfer mode on DSS key is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to
188.
To perform a semi-attended transfer:
Press
1.
Do one of the following:
2.
Enter the number you want to transfer the call to.
-
Press
- Tap the Directory soft key, and then tap All Contacts. Search for the contact and tap
the desired contact to dial out.
- Tap the Directory soft key, and then tap Remote Phone Book. Search for the contact
and tap the desired contact to dial out. (Remote phone book should be configured in
advance. Refer to
Tap the History soft key, and then tap the desired list. Tap the desired entry to dial
-
out.
Press
3.
If you are using a handset, the transfer can be completed by hanging up the handset.
164
or tap the Transfer soft key during a call.
or tap the Transfer soft key during a call.
or to dial out.
Remote Phone Book
or tap Transfer to complete the transfer when receiving ringback.
Configuring Transfer Mode on DSS Key
on page 90 for more information.)
on page