Manual Setting - Ricoh Ri 100 Operating Instructions Manual

2. Preparing for Printing
8. Enter the machine's PIN on the access point web page.
For details, see the manual supplied with the wireless LAN access point.
9. Execute WPS (PIN system) from the access point's web page.
10. Press the [Escape] key.
11. Press the [ ] or [ /Menu] key to select [PIN Method], and then press the [#Enter] key.
<Easy Setup>
PIN Method
If the connection attempt has failed, press the [#Enter] key again. If the problem persists, check
whether the access point is working properly.
Configuration is complete when connection to the access point is confirmed.
12. After you have made all the settings, press the [Escape] key.
13. Print the configuration page to check whether the machine has successfully connected to
the access point.
Check that the print media is set on the cassette.
Press the [ /Menu] key to display [List/Test Print], select [Config. Page], and then press the
[#Enter] key to print the configuration page. When the "WL.LAN Signal" indicating the Wireless
LAN signal in the configuration page is described as "(0%) Unavailable", the machine is not
connected to the access point.

Manual setting

If you cannot confirm the settings of the access point being used or the access point does not support
WPS, configure the wireless LAN settings manually.
You can configure the settings using Web Image Monitor or the control panel. This manual mainly
explains configuration using Web Image Monitor.
Configuring Settings Using Web Image Monitor
58
CHV609