Ricoh Ri 100 Operating Instructions Manual page 227

Message
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Causes
Thin fabric (up to 16 mm
(about 0.6 inches) thick)
is loaded on the bottom
row of the multi tray.
Thick fabric (16 to 32
mm (about 0.6 to 1.3
inches) thick) is loaded
on the top row of the
multi tray.
Fabric that is 4 mm
(about 0.2 inches) or
thicker is loaded on the
top row of the sleeve
attachment.
Fabric that is 20 mm
(about 0.8 inches) or
thicker is loaded on the
bottom row of the sleeve
attachment.
Fabric that is 4 mm
(about 0.2 inches) or
thicker is loaded on the
A4 standard tray or A5
tray.
Fabric that is 32 mm
(about 1.3 inches) or
thicker is loaded on the
multi tray or the sleeve
attachment.
Fabric is not set in the
center of the multi tray
table.
Error & Status Messages on the Display
Solutions
Load thin fabric (up to 16 mm (about 0.6
inches) thick) on the top row of the multi tray.
Load thick fabric (16 to 32 mm (about 0.6 to
1.3 inches) thick) on the bottom row of the
multi tray.
Load fabric that is 4 mm (about 0.2 inches)
or thicker on the bottom row of the sleeve
attachment.
Load fabric that is up to 20 mm (about 0.8
inches) thick on the top row of the sleeve
attachment.
Load fabric that is up to 4 mm (about 0.2
inches) thick on the A4 standard tray or A5
tray.
Load fabric that is up to 32 mm (about 1.3
inches) thick on the multi tray or the sleeve
attachment.
When setting the fabric in the multi tray, set it
in the center of the table.
225