Connecting The Machine Via A Wireless Lan Interface - Ricoh Ri 100 Operating Instructions Manual

The current IP address appears on the display.
6. Press the [ ] or [ /Menu] key to enter the left most entry field of the IP address, and then
press the [#Enter] key.
<IPv4 Address>
01 .022.033.044
To get an IP address for the machine, contact your network administrator.
The value moves by 10 if the [ ] or [ /Menu] key is kept pressed.
7. Press the [#Enter] key.
The entered value is confirmed, and the cursor moves to the next field.
<IPv4 Address>
192.02 .033.044
To return to the previous field, press the [Escape] key.
8. Specify values in all fields, and then press the [#Enter] key.
9. Specify "IPv4 Subnet M." and "IPv4 Gatewy.Ad." in the same way.
10. After you have made all the settings, press the [Escape] key.
The specified settings are set and the initial screen reappears.
You can print the configuration page to confirm the specified settings.
For details about how to print a configuration page, see page 117 "Printing a Configuration
Page".

Connecting the Machine via a Wireless LAN Interface

This section explains how to connect the machine to the network via a wireless LAN interface in the
infrastructure mode.
In the infrastructure mode, communication is established via a wireless LAN access point.
• Ad hoc mode is not supported.
• Ethernet and wireless LAN settings cannot be enabled at the same time.
Checking your wireless network environment
Before using the wireless LAN, configure the following settings and make the check.
Connecting the Computer and Installing the Software (Network Connection)
53