Ricoh Ri 100 Operating Instructions Manual page 65

Notes on the Installation
Although the Windows security warning may appear during installation, ignore it and continue with
the installation.
1. Insert the CD-ROM in the CD-ROM drive.
Quit all other applications currently running.
2. Select a language for the interface, and then click [OK].
3. Click [Quick Install for Network].
4. Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement.], and then click [Next >].
5. Check that the power of the machine turns on, the Ethernet cable is connected, and the IP
Address is set, and then click [Next].
The search for the network printer starts.
6. Click [Next >].
7. Click [Continue].
Installation starts.
8. If you want to make initial settings for the printer, click [Set Now].
9. Make initial settings, and then click [OK].
10. Select whether or not to open the Status Monitor automatically, and then click [Next >].
11. Click [Finish].
When the dialog box asking whether you want to restart now appears, select [Yes, restart now.],
and then click [Finish].
The printer driver is now installed.
• The installer launch automatically as Auto Run programs when you insert the CD-ROM. Auto Run
might not work automatically with certain OS settings. If this is the case, double-click "SETUP.EXE",
located on the CD-ROM root directory, or click [Run SETUP.EXE] in the [AutoPlay] dialog box.
• If a message prompting you to restart the computer appears, restart the computer.
• Confirm the printer driver is correctly installed by checking the Power lamp is lit, and then
performing a test print. To perform a test print, open the [Printer Properties] dialog box, click [Print
Test Page] on the [General] tab. If the test page does not print properly, see page 144 "Using the
[Host Interface] Menu".
Connecting the Computer and Installing the Software (Network Connection)
63