Ricoh Ri 100 Operating Instructions Manual page 228

9. Troubleshooting
Message
Cannot use High Temp. /
Power Off On
Cannot use Low Temp. /
Power Off On
Hardware Problem
Ethernet Board
Indepdnt.ink set
Indepdnt.ink set / Replace
Ink Crtg
Indepdnt.ink set / Press #
to continue
Ink Collector is not set /
Set the Ink Collector Unit
Ink Collector Unit is full /
Replace Ink Collector Unit
Low Ink
226
Causes
The temperature is
abnormally high.
The temperature is
abnormally low.
An error in the Ethernet
port (ethernet board)
network function has
occurred.
A non-genuine ink
cartridge was installed.
The ink collector unit is
not installed or is
installed incorrectly.
Alternatively, an ink
collector unit not meant
for this machine may be
installed.
The ink collector unit is
full.
The ink will soon run out.
Solutions
Check the installation area and relocate the
machine. Alternatively, wait until the machine
acclimates to the room temperature.
See page 235 "Out of Printable
Temperature Range".
Check the installation area and relocate the
machine. Alternatively, wait until the machine
acclimates to the room temperature.
See page 235 "Out of Printable
Temperature Range".
Disconnect all cables, turn the machine off,
and then turn it on again. If the message
reappears, contact your sales or service
representative.
See page 236 "Network Interface Error".
Use of non-genuine ink cartridges or refilled
ink cartridges may reduce print quality or
cause malfunctions.
See page 248 "Recommended
Consumables".
Install the ink collector unit for this machine
correctly. The ink collector unit meant for this
machine is labeled "J089" under its handle.
See page 234 "Ink Collector Unit Not
Detected/Wrong Unit".
Replace the ink collector unit.
See page 188 "Replacing an Ink Collector
Unit".
Make sure you have a new ink cartridge for
the color indicated by the
See page 233 "Cartridge Almost Empty".
icon.