A3 Maintenance; Arcing Current; Trip Counters; Mod 008 Upgrade - GE 750 Instruction Manual

CHAPTER 5: SETPOINTS

5.2.12 Mod 008 Upgrade


MOD 008
UPGRADE
750 FEEDER MANAGEMENT RELAY – INSTRUCTION MANUAL
The self-test warning message will be displayed until
Relay Not Ready
 
INSTALLATION 760 OPERATION
a relay whose setpoints have not been entered for the required application. This setpoint is
defaulted to "Not Ready" when the relay leaves the factory.
These setpoints should be used on a new installation or after new equipment has been
installed.
The
RESET TRIP COUNTER DATA
updates the

A3 MAINTENANCE

value. The
RESET ARCING CURRENT

A3 MAINTENANCE

ARCING CURRENT

The
RESET AR COUNT DATA
the
 
A1 STATUS AR AR SHOT COUNT LAST RESET
setpoint clears the autoreclose shot rate value and updates the
date. These two setpoints are applicable to the 760 only.
RESET

PATH: SETPOINTS S1 RELAY SETUP
[]
MESSAGE
MESSAGE
These setpoints are shown if the Mod 008 Reverse Power option has been ordered with the
750/760 relay. To order this option, please contact GE Multilin with the serial number of the
relay. Refer to Reverse Power on page 8–1 for the complete procedure for installing and
verifying the Reverse Power element.
These setpoints are shown only if the feature has been enabled.
is set to "Ready". This warns against the installation of
setpoint clears all accumulated trip counter values and
 

TRIP COUNTERS

TRIP COUNTERS LAST RESET
setpoint clears all arcing current data and updates the

ARCING CURRENT LAST RESET
setpoint clears the autoreclose shot count value and updates

MOD 008 UPGRADE
ENABLE MOD 008?
Disabled
ENTER PASSCODE:
00000000000000
UPGRADE OPTIONS?
No
S1 RELAY SETUP
S1 RELAY SETUP
date.
date. The
RESET AR RATE DATA
ARCING CURRENT LAST
Range: Disabled, Enabled
Range: 16 alphanumeric
characters
Range: Yes, No.
actual
5 - 21