Optiview HDVR4/8/16-Q2 User Manual page 264

Tour You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
PTZ Here you can set PTZ movement when an alarm occurs. Such as
go to preset X. See Figure 5-61.
Activation
Log Check the box here, system can record motion detect event log.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-62.
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest
setups, please refer to chapter 5.8.3.1.1 motion detect for detailed information.
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-63.
After analysis video, system can generate a tampering alarm when the detected moving
signal reached the sensitivity you set here.
For detailed setups, please refer to chapter 5.8.3.1.1 motion detect for detailed
information.
Figure 5-62
449