Table of Contents
Advertisement
Connecting to the Host
Ethernet Ports
On Board Ethernet
Connector
Reset Button
4–8
iSTAR eX Installation and Configuration Guide
Figure 4.3: Connecting Ethernet to iSTAR eX GCM
3. Place a ferrite clamp (PN 0444164181) on the Ethernet cable inside the
chassis, as shown in Figure 4.4.
4. Tighten the screws and reattach the connector to the board.
Figure 4.4: Ethernet Ferrite
- Quick Links:
- Istar Ex General Controller Module (Gcm)
- Icu
Hide quick links:
Advertisement
Table of Contents
