Pmb Controls And Indicators - Tyco iSTAR eX Installation And Configuration Manual

PMB Controls and Indicators

PMB Controls and Indicators
The PMB contains the following switches and reset buttons for use during
hardware setup and configuration.
SW1 – Multiplexes the four RM ports to the COM1 and COM2 ports on
the iSTAR eX GCM. Read1/Read2 to COM1 and Read3/Read4 to COM2
by default.
S5 Reset button – Do not use. Use SW2 on the iSTAR eX GCM to reset the
iSTAR eX.
LED indicators – indicate power, RS-485 transmit, and RS-485 receive.
Figure A.2 shows iSTAR eX PMB controls and LEDs.
Figure A.2: PMB Controls and Indicators
iSTAR eX Installation and Configuration Guide A–5