Starting The Diagnostic Utility - Tyco iSTAR eX Installation And Configuration Manual

Starting the Diagnostic Utility

Starting the Diagnostic Utility

NOTE
NOTE
6–2 iSTAR eX Installation and Configuration Guide
Use the following procedure to start the Diagnostic Utility and connect to a
controller.
To start the Diagnostic Utility
1. In an Internet Explorer browser window, enter the IP Address of the
iSTAR eX controller (for example, http://121.21.121.12) in the browser
Address window and press Enter or click Go. The Enter Network
Password dialog box appears.
You can also start the Diagnostic Utility from the ICU. See
"Using the iSTAR Configuration Utility (ICU)".
Figure 6.1: Enter Network Password Dialog Box
2. In both the User Name and Password fields, enter the password you
configured in the C•CURE 800/8000 or C•CURE 9000 Administration
application. (Configure in System Variables)
After the login information has been verified, the Controller Status
window appears, as shown in Figure 6.2 on
The password that you enter for the Diagnostic Utility is different from the
one used for the ICU.
Chapter
page 6-3.
5,