Table of Contents
Advertisement
Configuring SNMP
On iSTAR controllers running firmware version 4.0.0 or greater, you can
enable and configure Simple Network Management Protocol (SNMP)
communication.
SNMP communication is enabled on all iSTAR controllers by default. You can
use the ICU to do the following:
Configure up to two SNMP community names.
Select the security level for each community name.
Specify an SNMP trap manager.
Restrict SNMP communication to a particular SNMP host.
Add the contact information for the person who administers SNMP at
your site.
To configure SNMP
1. In the ICU controller list, select the iSTAR controller for which you want
to enable SNMP.
2. Right-click and select Edit Controller Information.
3. Select the Advanced tab, shown in Figure 5.9.
iSTAR eX Installation and Configuration Guide
Configuring SNMP
5–29
- Quick Links:
- Istar Ex General Controller Module (Gcm)
- Icu
Hide quick links:
Advertisement
Table of Contents
