Tyco iSTAR eX Installation And Configuration Manual page 161

Table 5.7: Ethernet Adapter Tab (Continued)
Field/Option
Use the following
Domain Name Server
addresses
Section
Primary Host
Connection
- or -
Primary Master
Connection
Secondary Host
Connection
- or -
Secondary Master
Connection
Description
Select this option if you want to specify the Domain
Name Server(s) that the controller should use. Then
enter the IP addresses of the Primary and Secondary
DNS Servers in the provided fields.
Optionally, you can also enter a DNS Query Suffix (for
example, "yourcompany.com").
Table 5.8: Host/Master Tab
Description
Connection Type – Defines the primary connection to
the C•CURE host or the master controller. Selections
include:
Onboard Ethernet 1 – connects via 10/100Base-T
Ethernet.
IP Address or Name – Specifies the IP address of the
C•CURE host (if configuring a master) or master
controller (if configuring a member).
When configuring a master controller, you can enter the
NetBIOS or DNS name of the C•CURE host. When
configuring a member controller, you can only enter the
IP address of the master controller.
Note: If the iSTAR eX is part of an AutoStart /
Replistor redundant configuration, you
must enter the NetBIOS or DNS name of
the host or master controller.
Defines the type of secondary connection to the
C•CURE host or master controller. Options include:
Onboard Ethernet 2– connects via 10/100Base-T
Ethernet
iSTAR eX Installation and Configuration Guide
Configuring a Controller
5–27