Hot-Swap Power Supply Replacement; Remove A Hot-Swap Power Supply - Lenovo thinksystem SR630 Maintenance Manual

Before installing the front I/O assembly, touch the static-protective package that contains the new front I/O
assembly to any unpainted surface on the outside of the server. Then, take the new front I/O assembly out of
the package and place it on a static-protective surface.
To install the front I/O assembly, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Table 19. Front I/O assembly installation
Figure 111. Server models with four
3.5-inch drive bays
Step 1. Insert the front I/O assembly into the assembly bay.
Step 2. Install the screws to secure the front I/O assembly in place.
After installing the front I/O assembly:
1. Connect the cables of the front I/O assembly to the system board. For the location of the connectors on
the system board, refer to "System board components" on page 24.
2. Complete the parts replacement. See "Complete the parts replacement" on page 141.

Hot-swap power supply replacement

Use this information to remove and install a hot-swap power supply.

Remove a hot-swap power supply

Use this information to remove a hot-swap power supply.
S035
Figure 112. Server models with eight
2.5-inch drive bays
Figure 113. Server models with ten
2.5-inch drive bays
.
Chapter 3 Hardware replacement procedures
113