Remove The Backplane For Ten 2.5-Inch Hot-Swap Drives - Lenovo thinksystem SR630 Maintenance Manual

Before installing the backplane, touch the static-protective package that contains the new backplane to any
unpainted surface on the outside of the server. Then, take the new backplane out of the package and place it
on a static-protective surface.
To install the backplane, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Figure 68. Installation of backplane for eight 2.5-inch hot-swap drives
Step 1. Align the two pins
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
After installing the backplane:
1. Connect the cables to the backplane. See "Server models with eight 2.5-inch drives" on page 31.
2. Reinstall all the drives and drive fillers into the drive bays. See "Install a hot-swap drive" on page 66.
3. Complete the parts replacement. See "Complete the parts replacement" on page 141.

Remove the backplane for ten 2.5-inch hot-swap drives

Use this information to remove the backplane for ten 2.5-inch hot-swap drives.
1 on the backplane with the corresponding holes 2 in the chassis.
.
Chapter 3 Hardware replacement procedures
79