Serial Port Module Replacement; Remove The Serial Port Module - Lenovo thinksystem SR630 Maintenance Manual

Figure 87. RAID adapter installation
Step 1. Place the RAID adapter into the slot at an angle.
Step 2. Rotate the RAID adapter down.
Step 3. Push the right-side latch open.
Step 4. Push the RAID adapter to the fully horizontal position and insert it into the RAID adapter slot.
Step 5. Slide the left-side latch to the locked position.
After installing the RAID adapter on the system board:
1. Connect cables to the new RAID adapter. See "Internal cable routing" on page 27.
2. Complete the parts replacement. See "Complete the parts replacement" on page 141.

Serial port module replacement

Use this information to remove and install the serial port module.
Note: The serial port module is available only on some models.

Remove the serial port module

Use this information to remove the serial port module.
Before removing the serial port module, remove the top cover. See "Remove the top cover" on page 42.
To remove the serial port module, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Note: The serial port module might be installed on riser 1 assembly or riser 2 assembly. The following steps
are based on the scenario that the serial port module is installed on riser 2 assembly. The removal procedure
is the same for the serial port module installed on riser 1 assembly.
Step 1. Disconnect the cable of the serial port module from the system board.
Step 2. Grasp the riser assembly with the serial port module and carefully lift it out of the server.
.
Chapter 3 Hardware replacement procedures
97