After installing the serial port module, complete the parts replacement. See "Complete the parts
replacement" on page 141.
M.2 backplane and M.2 drive replacement
Use this information to remove and install the M.2 backplane and M.2 drive (an assembled M.2 backplane
and M.2 drive is also known as M.2 module).
Remove the M.2 backplane and M.2 drive
Use this information to remove the M.2 backplane and M.2 drive.
Before removing the M.2 backplane and M.2 drive:
1. Remove the top cover. See "Remove the top cover" on page 42.
2. For easier operation, remove the riser assembly next to the M.2 backplane. See "Remove a riser card"
on page 70.
To remove the M.2 backplane and M.2 drive, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Step 1.
Grasp the M.2 backplane at both ends and pull it straight up to remove it from the system board.
Figure 92. M.2 backplane removal
Step 2.
Remove the M.2 drive from the M.2 backplane.
100
ThinkSystem SR630 Maintenance Manual