Lenovo thinksystem SR630 Maintenance Manual page 107

To install the serial port module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Note: The serial port module can be installed on riser 1 assembly or riser 2 assembly. The following steps
are based on the scenario that the serial port module is to be installed on riser 2 assembly. The installation
procedure is the same for the serial port module to be installed on riser 1 assembly.
Step 1. Grasp the riser assembly by its edges and carefully lift it out of the server.
Figure 90. Riser assembly removal
Step 2. If the riser assembly is covered with a PCIe slot bracket, remove the bracket first. Then, install the
serial port module into the riser assembly.
Figure 91. Serial port module installation
Step 3. Insert the riser assembly into the riser slot on the system board. Ensure that the riser assembly is
fully seated.
Step 4. Connect the cable of the serial port module to the serial-port-module connector on the system
board. For the location of the serial-port-module connector, refer to "System board components"
on page 24.
.
Chapter 3 Hardware replacement procedures
99