Table of Contents
Advertisement
"Read the
installation
Guidelines" on
page 79
Before installing the front I/O assembly, touch the static-protective package that contains the new front I/O
assembly to any unpainted surface on the outside of the server. Then, take the new front I/O assembly out of
the package and place it on a static-protective surface.
To install the front I/O assembly, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku:
http://list.youku.com/albumlist/show/id_52222446.html
Table 17. Front I/O assembly installation
Figure 160. Server models with four 3.5-inch drive bays
Step 1.
Insert the front I/O assembly into the assembly bay.
Step 2.
Install the screws to secure the front I/O assembly in place.
After installing the front I/O assembly:
1. Connect the cables of the front I/O assembly from the front I/O assembly to the system board. For the
location of the connectors on the system board, refer to "System board components" on page 21.
2. Complete the parts replacement. See "Complete the parts replacement" on page 203.
Hot-swap power supply replacement
Use this information to remove and install a hot-swap power supply.
Remove a hot-swap power supply
Use this information to remove a hot-swap power supply.
ThinkSystem SR635 Maintenance Manual
174
"Power off
the server for
this task" on
page 11
Figure 161. Server models with eight/ten 2.5-inch drive
bays
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 82
Advertisement
Table of Contents
