Lenovo thinksystem SR630 Maintenance Manual page 131

a. Press down the stop bracket
b. Rotate the CMA out of the way to gain access to the power supply bay.
Step 2. Remove the power-supply filler.
Figure 119. Hot-swap power supply filler removal
Step 3. Slide the new hot-swap power supply into the bay until the release latch clicks into place.
Figure 120. Hot-swap power supply installation
After installing the power supply:
1. Connect one end of the power cord to the new power supply connector; then, connect the other end of
the power cord into a properly grounded electrical outlet.
2. If the server is powered off, power on the server. Ensure that both the power input LED and power
output LED on the power supply are lit, indicating that the power supply is operating properly.
1 and rotate it to the open position.
Chapter 3
.
Hardware replacement procedures
123