Update The Universal Unique Identifier (Uuid) - Lenovo thinksystem SR630 Maintenance Manual

Figure 129. System board installation
Step 1. Hold the release pin
chassis.
Step 2. Slide the system board to the rear of the server until the system board snaps into position. Ensure
that:
• The new system board is engaged by the mounting stud
• The rear connectors on the new system board are inserted into the corresponding holes in the
rear panel.
• The release pin
After installing the system board:
1. Push the power supplies into the bays until they click into place.
2. Install any components that you removed from the failing system board. See the related topics in
Chapter 3 "Hardware replacement procedures" on page 39.
3. Complete the parts replacement. See "Complete the parts replacement" on page 141.
4. Update the Universal Unique Identifier (UUID). See "Update the Universal Unique Identifier (UUID)" on
page 134.
5. Update the SMBIOS/DMI information. See "Update the DMI/SMBIOS data" on page 136.
6. Enable TPM/TCM. See "Enable TPM/TCM" on page 138.
7. Optionally, enable Secure Boot.

Update the Universal Unique Identifier (UUID)

The Universal Unique Identifier (UUID) must be updated when the system board is replaced. Use the Lenovo
XClarity Essentials OneCLI to update the UUID in the UEFI-based server. Lenovo XClarity Essentials OneCLI
is an online tool that supports several operating systems; make sure that you download the version for your
operating system.
134
ThinkSystem SR630 Maintenance Manual
1 2
and the lift handle
1 secures the system board in place.
at the same time to lower the system board into the
3 on the chassis.