Hot-Swap Drive Replacement - Lenovo thinksystem SR630 Maintenance Manual

Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Figure 45. DIMM installation
Step 1. Open the retaining clips on each end of the DIMM slot.
Attention: To avoid breaking the retaining clips or damaging the DIMM slots, open and close the
clips gently.
Step 2. Align the DIMM with the slot, and firmly press both ends of the DIMM straight down into the slot
until the retaining clips snap into the locked position.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly
inserted; open the retaining clips, remove the DIMM, and then reinsert it.
After installing a DIMM, complete the parts replacement. See "Complete the parts replacement" on page
141.

Hot-swap drive replacement

Use this information to remove and install a hot-swap drive. You can remove or install a hot-swap drive
without turning off the server, which helps you avoid significant interruption to the operation of the system.
Notes:
• The term "hot-swap drive" refers to all the supported types of hot-swap hard disk drives, hot-swap solid-
state drives, and hot-swap NVMe drives.
64
ThinkSystem SR630 Maintenance Manual