Connecting The Model 8230 To Your Computer - AEMC 8230 User Manual

NOTE: The installation of the drivers may take a few moments. Windows may
even indicate that it is not responding, however it is running. Please wait for it to
finish.
11. When the drivers are finished installing, the Installation Successful dialog
box will appear. Click on OK.
12. Next, the Installation Wizard Complete window will appear. Click on Finish.
13. A Question dialog box appears next. Click Yes to read the procedure for con-
necting the instrument to the USB port on the computer.
NOTE: The Set-up window remains open. You may now select another option to
download (e.g. Adobe
14. Restart your computer, then connect the instrument to the computer.
15. Once connected, the Found New Hardware dialog box will appear. Windows
will complete the driver installation process automatically.
Shortcuts for DataView
installation process have been added to your desktop.
NOTE: If you connected your instrument to the computer before installing the
software and drivers, you may need to use the Add/Remove Hardware utility to
remove the instrument driver before repeating the process.

6.2 Connecting the Model 8230 to your Computer

The Model 8230 is supplied with an optically isolated USB interface cable re-
quired for connecting the instrument to the computer. This cable (Cat. #2135.41)
is equipped with a USB type A on one end, and an optical connector on the other
end.
To connect the Model 8230 to your computer:
1. Connect the optical connector end of the cable to the serial port on the
side panel of the Model 8230 (see Figure 2-1, item 8)
2. Connect the USB type A end of the cable to an available USB port on your
computer.
You are now ready to use the DataView
56
Reader), or close the window.
®
and each instrument control panel selected during the
®
®
software with the 8230.
Power Quality Analyzer Model 8230